EasyManua.ls Logo

Huawei quidway s7700 - Checking Connectivity of the VPLS Network

Huawei quidway s7700
833 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Procedure
l Run:
mac-populate vsi vsi-name mac mac-address [ packet-num num | flood ] *
A test on the MAC address learning capacity is initiated by adding an OAM MAC address
to the device.
vsi vsi-name: specifies the name of the VSI of which the MAC address learning
capability needs to be diagnosed.
mac mac-address: only 10 OAM MAC addresses are supported currently.
0018-82a4-3fb1
0018-82a4-3fb2
0018-82a4-3fb3
0018-82a4-3fb4
0018-82a4-3fb5
0018-82a4-3fb6
0018-82a4-3fb7
0018-82a4-3fb8
0018-82a4-3fb9
0018-82a4-3fba
packet-num num: specifies the number of the sent diagnosis packets. The value is a
decimal integer that ranges from 1 to 5. The default value is 3.
flood:indicates that diagnose packets are flooded in the VPLS network. In this case,
both the local device and the peer device configured with the same VSI can learn the
specified OAM MAC address. If this parameter is not specified, only the PE where the
command is run can learn the specified OAM MAC address.
The OAM MAC address populated into the local and peer devices can control the
forwarding. According to the OAM MAC address, the peer device forwards the received
packets corresponding to the OAM MAC address to the local device. The aging time
of OAM MAC addresses is set to 150 seconds.
l Run:
mac-purge vsi vsi-name mac mac-address [ packet-num num | register | flood ] *
An OAM MAC address is purged from the forwarding table.
flood:If this parameter is not specified, only the PE where the command is run can
remove the specified OAM MAC address. If this parameter is specified, the diagnose
packets are flooded in the VPLS network. In this case, both the local device and the
peer device configured with the same VSI can remove the specified OAM MAC address.
register:indicates that the specified OAM MAC address becomes the blackhole MAC
address, and all the packets destined for this address are discarded.
----End
7.12.9 Checking Connectivity of the VPLS Network
The ping and tracert commands can be used to detect the connectivity of the VPLS network.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
729

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals