Huawei quidway s7700 - Checking the Configuration; Configuring a Static PW

If you specify a PW attribute by using a command line, the same PW attribute specified in the
PW template does not function on the PW to which this PW template is applied.
NOTE
Modifying the attributes of a PW template causes the disconnection and re-establishment of a PW. If
multiple PWs use this template at the same time, the system operation is affected. To avoid this, run the
reset pw pw-template command to validate the new configuration after modifying the attributes of a PW
template.
6.3.4 Checking the Configuration
After a PW attribute/template is configured, you can view information such as the name of the
PW template and the configuration of the PW attribute.
Context
The configurations of the attributes of a PW template are complete.
Procedure
l Run the display pw-template [ pw-template-name ]. command to check information about
the PW template.
----End
Example
Run the display pw-template command. You can view the configured PW template name and
parameters. For example:
<Quidway> display pw-template
Total PW template number : 1
PW Template Name : 1to3
PeerIP : 3.3.3.3
Tnl Policy Name : --
CtrlWord : Enable
MTU : 1500
Max Atm Cells : 1
ATM Pack Overtime: 1000
Seq-Number : Disable
TDM Encapsulation Number: 32
Jitter-Buffer : 20
Idle-Code : ff
Rtp-Header : Disable
VCCV Capability : cw alert lsp-ping bfd
Behavior Name : --
Total PW : 1, Static PW : 0, LDP PW : 1
6.4 Configuring a Static PW
This section describes how to configure a static PW. A static PW transmits L2VPN packets
between PEs without using a signaling protocol.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 6 PWE3 Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
554