Huawei quidway s7700 - Configuring the Mvsi

Pre-configuration Tasks
Before configuring basic functions of VPLS convergence (UPE directly accesses the NPEs),
complete the following tasks:
l Setting the LSR ID on the UPE and the NPE, enabling MPLS, and creating an MPLS LDP
session
l Enabling MPLS L2VPN on the UPE and the NPE
l Configuring the mVRRP and the binding relations for the mVRRP on the NPE
l Configuring a service VSI on the UPE
Data Preparation
To configure basic functions of VPLS convergence (UPE directly accesses the NPEs), you need
the following data.
No. Data
1 Names and IDs of the mVSI and the service VSI
2 IP address of the peer and the tunnel policy used by the PW
3 Name and number of the interface to which a VSI is bound
8.3.2 Configuring the mVSI
Context
To forward the mVRRP packets on the NPEs through the mVSI on the UPE, do as follows.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vsi vsi-name static
A VSI is created and the automatic member discovery mechanism is configured.
Step 3 Run:
pwsignal ldp
LDP is configured as the signaling protocol of the PW and the VIS-LDP view is displayed.
Step 4 Run:
vsi-id vsi-id
The ID of the VSI is set.
Step 5 Run:
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 8 VPLS Convergence Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
805