Huawei quidway s7700 - Example for Configuring a Dynamic SH-PW

To Next Page

To Previous Page

6.13.1 Example for Configuring a Dynamic SH-PW

Networking Requirements

As shown in Figure 6-12, PE1 and PE2 are connected through an MPLS backbone network.

An LSP needs to be used to set a dynamic PW between PE1 and PE2.

Figure 6-12 Networking diagram for configuring a dynamic SH-PW (using LSP)

PE2

CE1

CE2

Loopback0

192.2.2.2/32

GE2/0/0

GE1/0/0

GE2/0/0

GE1/0/0

GE1/0/0 GE1/0/0

GE1/0/0

Loopback0

192.4.4.4/32

Loopback0

192.3.3.3/32

PE1 P

MPLS Backbone

Device Interface VLANIF interface IP address

PE1 GigabitEthernet1/0/0 VLANIF 10 -

GigabitEthernet2/0/0 VLANIF 20 10.1.1.1/24

Loopback1 - 192.2.2.2/32

PE2 GigabitEthernet1/0/0 VLANIF 30 -

GigabitEthernet2/0/0 VLANIF 40 10.2.2.2/24

Loopback1 - 192.3.3.3/32

P GigabitEthernet1/0/0 VLANIF 20 10.1.1.2/24

GigabitEthernet2/0/0 VLANIF 40 10.2.2.1/24

Loopback1 - 192.4.4.4/32

CE1 GigabitEthernet1/0/0 VLANIF 10 100.1.1.1/24

CE2 GigabitEthernet1/0/0 VLANIF 30 100.1.1.2/24

Configuration Roadmap

The configuration roadmap is as follows:

Quidway S7700 Smart Routing Switch

Configuration Guide - VPN 6 PWE3 Configuration

Issue 01 (2011-07-15) Huawei Proprietary and Confidential

589

Other manuals for Huawei quidway s7700