EasyManua.ls Logo

Huawei quidway s7700 - Checking the Configuration

Huawei quidway s7700
833 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
A Layer 2 interface is switched to a Layer 3 interface.
When using XGE, GE, Ethernet, and Eth-Trunk interfaces as AC interfaces, run this command
to switch Layer 2 interfaces to Layer 3 interfaces.
Step 4 Run:
mpls l2vc { ip-address | pw-template pw-template-name }
*
vc-id [ group-id group-
id | tunnel-policy policy-name | [ control-word | no-control-word ] | [ raw |
tagged ] | mtu mtu-value ]
*
secondary
A backup VC is configured.
The ID of the backup VC must be different from that of the master VC.
----End
6.7.3 Checking the Configuration
After a backup PW is configured, you can view information about the backup PW.
Context
The configurations of the backup PW are complete.
Procedure
l Run the display mpls l2vc [ vc-id | interface interface-type interface-number | remote-
info [ vc-id ] | state { down | up } ] command to check the status of a PW.
----End
Example
After the configuration is successful, the following results are displayed when the display mpls
l2vc [ vc-id | interface interface-type interface-number | remote-info [ vc-id ] | state { down |
up } ] command is used on the PE to which a CE is connected through only one link:
l The statuses of the master and backup PWs are up.
l VC state of the master PW is active, and VC state of the backup PW is inactive.
For example:
<Quidway> display mpls l2vc interface vlanif 10
*client interface : Vlanif10 is up
session state : up
AC state : up
VC state : up
VC ID : 100
VC type : VLAN
destination : 3.3.3.3
local group ID : 0 remote group ID : 0
local VC label : 23552 remote VC label : 23553
local AC OAM State : up
local PSN State : up
local forwarding state : forwarding
local status code : 0x0
remote AC OAM state : up
remote PSN state : up
remote forwarding state: forwarding
remote statuscode : 0x0
BFD for PW : available
BFD sessionIndex : 257 BFD state : up
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 6 PWE3 Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
566

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals