Huawei quidway s7700 - Example for Configuring Hub&Spoke (Using BGP4+ between PE and CE)

ipv6
#
vlan batch 101 1011
#
interface Vlanif101
ipv6 enable
ipv6 address 2005::1/64
ripng 100 enable
#
interface Vlanif1011
ipv6 enable
ipv6 address 1999::1/64
ripng 100 enable
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 101
port hybrid untagged vlan 101
#
interface GigabitEthernet2/0/0
port hybrid pvid vlan 1011
port hybrid untagged vlan 1011
#
ripng 100
#
return
4.11.2 Example for Configuring Hub&Spoke (Using BGP4+
Between PE and CE)
Networking Requirements
As shown in Figure 4-3, the communication between Spoke-CEs is controlled by the Hub-CE
in the central site. That is, the traffic between Spoke-CEs is forwarded by the Hub-CE, and not
only by the Hub-PE. You need to configure BGP4+ between Hub-PE and Hub-CE, and between
Spoke-PE and Spoke-CE.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 4 BGP MPLS IPv6 VPN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
383