Huawei quidway s7700 - Configuring VSI-Based Traffic Suppression

To Next Page

To Previous Page

Figure 7-11 Networking where the VPLS network is deployed over the edge layer

UPE

PE-AGG

PE-AGG NPE

NPE

VPLS

DSLAM

Access Ethernet Aggregation Edge

Pre-configuration Tasks

Before configuring the suppression on broadcast traffic based on VSIs, complete the following

task:

Configuring Kompella VPLS or Configuring Martini VPLS

Data Preparation

To configure the suppression on broadcast traffic based on VSIs, you need the following data.

No.

Data

1 Name of VSI

2 Type of the traffic to be suppressed (broadcast, multicast, or unknown unicast)

3 Committed information rate (CIR), that is, the maximum transmission rate of the

traffic that can pass through

4 Committed burst size (CBS), that is, the maximum size of traffic that can pass through

7.11.2 Configuring VSI-based Traffic Suppression

Context

Do as follows on the PEs on which the VSI broadcast traffic, multicast traffic, and unknown

unicast traffic need to be suppressed.

Quidway S7700 Smart Routing Switch

Configuration Guide - VPN 7 VPLS Configuration

Issue 01 (2011-07-15) Huawei Proprietary and Confidential

722

Other manuals for Huawei quidway s7700