Data Preparation
To configure the HVPLS, you need the following data.
No. Data
1 Corresponding relationship between the UPE and the SPE
2 IP address of the peer
3 VSI name, VSI ID, and the interface bound with VSI
4 Tunnel policy
7.5.2 Configuring SPE
This part describes how to configure an SPE to establish VSI peer relationships with other SPEs,
and with UPEs.
Context
Do as follows on the SPE.
Procedure
Step 1 Run
system-view
The system view is displayed.
Step 2 Run:
vsi vsi-name static
The VSI is created and the static member discovery mechanism is adopted.
Step 3 Run:
pwsignal ldp
The PW signaling protocol is specified as the LDP and the VSI-LDP view is displayed.
Step 4 Run:
vsi-id vsi-id
The VSI ID is configured.
Step 5 Run:
peer peer-address [ negotiation-vc-id vc-id ] [ tnl-policy policy-name ]
The VSI peer between the SPEs is configured.
Step 6 Run:
peer peer-address [ negotiation-vc-id vc-id ] [ tnl-policy policy-name ]upe
The VSI peer between the SPE and the UPE is configured.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
698
To Next Page
Loading...
