EasyManua.ls Logo

Huawei quidway s7700 - Configuring a Dynamic PW; Establishing the Configuration Task

Huawei quidway s7700
833 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Procedure
l Run the display mpls static-l2vc [ vc-id | interface interface-type interface-number |
state { down | up } ] command to check information about a specified static PW on a PE.
----End
Example
Run the display mpls static-l2vc [ vc-id | interface interface-type interface-number | state
{ down | up } ] command. You can see that VC State of the PW is up. For example:
<Quidway> display mpls static-l2vc interface vlanif 10
*Client Interface : vlanif 10 is up
AC Status : up
VC State : up
VC ID : 100
VC Type : VLAN
Destination : 3.3.3.9
Transmit VC Label : 100
Receive VC Label : 100
Control Word : Disable
VCCV Capability : alert lsp-ping bfd
Tunnel Policy : --
PW Template Name : pwt
Traffic Behavior : --
Main or Secondary : Main
VC tunnel/token info : 1 tunnels/tokens
NO.0 TNL Type : lsp , TNL ID : 0x2002003
Create time : 0 days, 0 hours, 13 minutes, 7 seconds
UP time : 0 days, 0 hours, 10 minutes, 23 seconds
Last change time : 0 days, 0 hours, 10 minutes, 23 seconds
VC last up time : 2010/11/24 12:31:31
VC total up time : 0 days, 2 hours, 12 minutes, 51 seconds
CKey : 2
NKey : 1
6.5 Configuring a Dynamic PW
This section describes how to configure a dynamic PW. To configure a dynamic PW, extended
LDP needs to be used to transmit Layer 2 information and VC labels.
6.5.1 Establishing the Configuration Task
Before configuring a dynamic PW, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task correctly and quickly.
Applicable Environment
A dynamic PW uses extended LDP to transmit Layer 2 information and VC labels, and needs
to be configured on PEs of both ends of a PW.
Pre-configuration Tasks
Before configuring a dynamic PW, complete the following tasks:
l Configuring an IGP on PEs and Ps on the MPLS backbone to implement IP interworking
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 6 PWE3 Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
557

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals