Huawei quidway s7700 - Optional) Configuring the Features of Kompella VPLS

NOTE
Member interfaces of a trunk cannot be Eth-Trunk interfaces.
5. Run:
eth-trunk trunk-id
The interface is added into the Eth-Trunk.
Before adding an interface into an Eth-Trunk, ensure the interface is not configured
with any Layer 3 attributes such as IP address and any services.
An Ethernet interface can join only one Eth-Trunk interface. To join another Eth-
Trunk interface, the Ethernet interface must quit from the original one.
Member interfaces of an Eth-Trunk interface must be of the same type. That is, FE
interfaces and GE interfaces cannot join an Eth-Trunk interface.
6. Run:
quit
Return to the system view.
7. Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
8. (Optional) Run:
undo portswitch
The Layer 2 interface is configured as a Layer 3 interface.
9. Run:
l2 binding vsi vsi-name
The Eth-Trunk interface is bound with the VSI.
----End
7.3.6 (Optional) Configuring the Features of Kompella VPLS
Kompella VPLS features include RR, reflection policy, and disabling VPN-target-based filtering
on received VPLS label blocks.
Context
The BGP VPLS sub-address family view is used to manage the VPLS label block.
Do as follows on the PEs of both ends of a PW:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp as-number
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
688