The VPN binding for the tunnel is enabled.
The tunnel policy in select-sequence mode cannot use the tunnel enabled with the VPN binding.
Step 4 Run:
mpls te commit
The current configuration is validated.
----End
1.6.3 Configuring the VPN Binding of the Tunnel Policy
After enabling VPN tunnel binding, you must also configure a tunnel policy to ensure that the
VPN data is transmitted along the bound tunnel.
Context
Do as follows on PEs at both ends of the TE tunnel.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
tunnel-policy policy-name
A tunnel policy is created.
Step 3 Run:
tunnel binding destination dest-ip-address te tunnel interface-number [ down-
switch ]
The peer address is bound with the tunnel policy. The VPN data from the local end are transmitted
to the destination address through the bound tunnel.
Note the following:
l Tunnel policy can be either in select-sequence mode or tunnel binding mode. Therefore, the
tunnel policy configured with the tunnel binding command cannot be then configured with
the tunnel select-seq command.
l A maximum of six tunnels can be bound to the same destination address for a PE.
l If the PE has multiple peers, a tunnel policy can be configured with multiple tunnel
binding commands with different destination address
----End
1.6.4 Applying the Tunnel Policy to the L3VPN
After a tunnel binding policy is applied to an L3VPN, the VPN data is transmitted along the
bound tunnel.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 1 VPN Tunnel Management Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
21
To Next Page
Loading...
