Huawei quidway s7700 - Enabling the VPN Binding for a Tunnel; Configuring the VPN Binding of the Tunnel Policy

1.7.2 Enabling the VPN Binding for a Tunnel
A tunnel can be bound to a VPN only after VPN tunnel binding is enabled.
Context
Only the tunnel enabled with the VPN binding can be bound with the VPN.
Do as follows on PEs at both ends of the TE tunnel.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface tunnel interface-number
The tunnel interface view of the MPLS TE is displayed.
Step 3 Run:
mpls te reserved-for-binding
The VPN binding forthe tunnel is enabled.
The tunnel policy in select-sequence mode cannot use the tunnel enabled with the VPN binding.
Step 4 Run:
mpls te commit
The current configuration is validated.
----End
1.7.3 Configuring the VPN Binding of the Tunnel Policy
After enabling VPN tunnel binding, you must also configure a tunnel policy to ensure that the
VPN data is transmitted along the bound tunnel.
Context
Do as follows on PEs at both ends of the TE tunnel.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
tunnel-policy policy-name
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 1 VPN Tunnel Management Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
25