Huawei quidway s7700 - Creating a Static PW; Checking the Configuration

mpls l2vpn
MPLS L2VPN is enabled.
Before configuring an MPLS L2VC connection, enable MPLS L2VPN.
----End
6.4.3 Creating a Static PW
Before configuring a static PW, you must specify the VC label.
Context
Do as follows on the PEs on the two ends of a PW:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number [ subinterface-number ]
The view of the interface attached to an AC is displayed.
Step 3 (Optional) Run:
undo portswitch
The Layer 2 interface is switched to a Layer 3 interface.
When using XGE, GE, Ethernet, and Eth-Trunk interfaces as AC interfaces, you need to run the
undo portswitch command to switch Layer 2 interfaces to Layer 3 interfaces.
Step 4 Run:
mpls static-l2vc { destination ip-address | pw-template pw-template-name vc-id }
*
transmit-vpn-label transmit-label-value receive-vpn-label receive-label-value
[ tunnel-policy tnl-policy-name | [ control-word | no-control-word ] | [ raw |
tagged ] ]
*
A static PW is configured.
NOTE
The parameters raw and tagged are specified in the command only when the link type is Ethernet.
----End
6.4.4 Checking the Configuration
After a static PW is configured, you can view information about the static PW.
Prerequisite
The configurations of the static PW function are complete.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 6 PWE3 Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
556