#
return
l Configuration file of CE2
#
sysname CE2
#
vlan batch 20
#
interface Vlanif20
ip address 30.1.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 20
#
return
5.11.6 Example for Configuring a Remote Kompella Connection
Networking Requirements
As shown in Figure 5-9, CE1 and CE2 are respectively connected to PE1 and PE2 through
GE interfaces.
A remote Kompella VLL is set up between CE1 and CE2.
Figure 5-9 Networking diagram for configuring a remote Kompella VLL
GE 2/0/0
GE 1/0/0 GE 2/0/0
GE 1/0/0
GE 1/0/0
P PE 2
PE 1
CE 1
CE 2
GE 2/0/0
GE 1/0/0
GE 1/0/0
Loopback1
1.1.1.9/32
Loopback1
2.2.2.9/32
Loopback1
3.3.3.9/32
Kompella
Remote
Device
Interface VLANIF interface IP address
PE1 GigabitEthernet1/0/0 VLANIF 10 -
GigabitEthernet2/0/0 VLANIF 20 168.1.1.1/24
Loopback1 - 1.1.1.9/32
PE2 GigabitEthernet1/0/0 VLANIF 30 169.1.1.2/24
GigabitEthernet2/0/0 VLANIF 40 -
Loopback1 - 3.3.3.9/32
P GigabitEthernet1/0/0 VLANIF 20 168.1.1.2/24
GigabitEthernet2/0/0 VLANIF 30 169.1.1.1/24
Loopback1 - 2.2.2.9/32
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 5 VLL Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
514
To Next Page
Loading...
