Huawei quidway s7700 - Enabling MPLS L2 VPN; Creating an SVC VLL Connection

No. Data
1 Type and number of the interface accessing CE
2 Destination LSR ID of SVC
3 In-label and out-label values of L2VPN connection
4 Tunnel policy of the SVC
5.4.2 Enabling MPLS L2VPN
Before configuring an SVC VLL, you must enable MPLS L2VPN.
Context
Do as follows on the PEs of the two ends of the VC:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
mpls l2vpn
The MPLS L2VPN is enabled.
----End
5.4.3 Creating an SVC VLL Connection
Context
Do as follows on the PEs on the two ends of the VC.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The AC interface view is displayed.
Step 3 (Optional) Run:
undo portswitch
The Layer 2 interface is configured as a Layer 3 interface.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 5 VLL Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
459