Huawei quidway s7700 - Configuring MP-IBGP between Hub-PE and Spoke-PE

You can bind VLANIF interfaces to IPv6 VPN instances.
Step 3 Run:
ipv6 enable
The IPv6 capability is enabled on the interface.
Step 4 Run:
ipv6 binding vpn6-instance vpn6-instance-name
The interface is bound with the IPv6 VPN instance.
NOTE
Running the ipv6 binding vpn6-instance command deletes the Layer 3 features such as IPv6 address and
IPv6 routing protocols. They need to be re-configured if required.
Step 5 Run:
ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }
The IPv6 address is configured.
----End
4.5.5 Configuring MP-IBGP Between Hub-PE and Spoke-PE
With extended community attributes added to BGP, MP-IBGP can advertise VPNv6 routes
between PEs.
Context
The Hub-PE must set up the MP-IBGP peer with all the Spoke-PEs. Spoke-PEs need not set up
the MP-IBGP peer between each other.
Do as follows on the Hub-PE and the Spoke-PE.
Procedure
Step 1 Run
system-view
The system view is displayed.
Step 2 Run
bgp as-number
The BGP view is displayed.
Step 3 Run
peer ipv4-address as-number as-number
The remote PE is specified as the peer.
Step 4 Run
peer ipv4-address connect-interface loopback interface-number
The interface to set up the TCP connection is specified.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 4 BGP MPLS IPv6 VPN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
345