EasyManua.ls Logo

Huawei quidway s7700 - Maintaining VLL; Enabling Traffic Statistics on the VLL

Huawei quidway s7700
833 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
manual fault set or not: not set
AC OAM state: up
BFD for PW session index: 257
BFD for PW state: up
BFD for LSP state: true
Local C bit is set, Remote C bit is set
tunnel type: lsp , id: 0x10004
Reroute policy : delay 30 s, resume 10 s
Reason of last reroute : --
Time of last reroute : -- days, -- hours, -- minutes, -- seconds
delay timer ID : -- rest time :--
resume timer ID : -- rest time :--
Run the display mpls l2vpn forwarding-info [ vc-label ] interface interface-type interface-
number command, and you can see that ENTRYTYPE of the master PW is SEND,
PWSTATE is ACTIVE, BFDSTATE is UP, and ADMIN is UP. The following is an example:
<Quidway> display mpls l2vpn forwarding-info interface vlanif 11
The Main PW Forward Information :
VCLABEL TNLTYPE ENTRYTYPE PWSTATE BFDSTATE ADMIN CTLWORD CC CV TNLID
---------------------------------------------------------------------------
23552 CRLSP SEND ACTIVE UP UP TRUE 1 8 0x20002
1 Record(s) Found.
The Second PW Forward Information :
VCLABEL TNLTYPE ENTRYTYPE PWSTATE BFDSTATE ADMIN CTLWORD CC CV TNLID
---------------------------------------------------------------------------
23552 LSP SEND INACTIVE UP UP TRUE 1 8 0x10004
1 Record(s) Found.
5.10 Maintaining VLL
This section describes how to maintain a VLL. Detailed operations include resetting the BGP
connection of the VLL, and monitoring the L2VPN running status.
5.10.1 Enabling Traffic Statistics on the VLL
This section describes how to enable the function of collecting statistics on VLL traffic before
viewing VLL traffic statistics.
Context
You can collect statistics on VLL traffic on the user-side interfaces that are bound to the VLL.
In this case, you need to enable the function of collecting statistics on VLL traffic on the device
before the VLL connection is set up.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
mpls l2vpn traffic-statistics enable
The traffic statistics on the VLL is enabled.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 5 VLL Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
485

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals