l Run the debugging mpls packet [ error ] [ acl acl-number ] [ inlabel outer-in-label
[ inner-in-label ] ] [ l2vpn-in-interface interface-type interface-number ] command in the
user view to enable the MPLS packet debugging.
l Run the debugging mpls ldp { advertisement | all | error | main | notification | pdu |
session | socket | timer } [ interface interface-type interface-number ] or debugging
mpls ldp { hsb | remote-peer remote-peer-name }command in the user view to enable the
LDP debugging..
----End
7.12.6 Enabling or Disabling VSI
Sometimes, to halt services, you can disable a VSI temporarily, and then add, cancel, or adjust
VSI functions.
Context
Do as follows in the VSI view.
Procedure
l Enable VSI
1. Run the system-view command to enter the system view.
2. Run the vsi vsi-name command to enter the vsi view.
3. Run the undo shutdown command to check enable VSI.
l Disable VSI
1. Run the system-view command to enter the system view.
2. Run the vsi vsi-name command to enter the vsi view.
3. Run the shutdown command to check disable VSI.
----End
Example
Regarding requirements of service management such as service suspension, you can temporarily
shut down the VSI, and then add, delete or adjust the VSI function.
The shutdown command affects the PW connection. The AC is Down, and the Layer 2
forwarding table is deleted.
7.12.7 Clearing MAC Address Entries
The deleted MAC address entries cannot be restored. Therefore, conform the action with caution.
Context
CAUTION
After the MAC address entries are cleared, the entries cannot be restored. So, confirm the action
before you clear the entries.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
727
To Next Page
Loading...
