8. Run:
interface interface-type interface-number
The interface view is displayed.
9. Run:
isis ipv6 enable [ process-id ]
IS-IS IPv6 is enabled on the interface.
10. Run:
quit
Return to the system view.
11. Run:
bgp as-number
The BGP view is displayed.
12. Run:
ipv6-family vpn6-instance vpn6-instance-name
The BGP-VPN6 instance view is displayed.
13. Run:
import-route isis process-id [ med med | route-policy route-policy-name ]
*
The IS-IS route is installed to the BGP-VPNv6 instance routing table.
----End
4.4.6 Checking the Configuration
After configuring the basic BGP/MPLS IPv6 VPN function, you can view IPv6 VPN routing
information about the local and remote sites on the PE or the CE.
Prerequisite
The configurations of the Basic BGP/MPLS IPv6 VPN function are complete.
Procedure
l Run the display ipv6 routing-table vpn6-instance vpn6-instance-name command to
check the routing table of the specified IPv6 VPN instance on PE.
l Run the display ipv6 routing-table command to check the routing table on CE.
----End
Example
Run the display ipv6 routing-table vpn6-instance vpn6-instance-name command. If the VPN
routes related to the CE are displayed, it means the configuration succeeds.
Run the display ipv6 routing-table command. If the routes to the remote CE are displayed on
the CE, it means the configuration succeeds.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 4 BGP MPLS IPv6 VPN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
339
To Next Page
Loading...
