EasyManua.ls Logo

Huawei quidway s7700 - Checking the Configuration

Huawei quidway s7700
833 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The system view is displayed.
Step 2 Run:
interface interface-type interface-number [ .subinterface-number ]
The interface view of the interface attached to an AC is displayed.
Step 3 (Optional) Run:
undo portswitch
A Layer 2 interface is switched to a Layer 3 interface.
When using XGE, GE, Ethernet, and Eth-Trunk interfaces as AC interfaces, run this command
to switch Layer 2 interfaces to Layer 3 interfaces.
Step 4 Run:
mpls l2vc { ip-address | pw-template pw-template-name }
*
vc-id [ group-id group-
id | tunnel-policy policy-name | [ control-word | no-control-word ] | [ raw |
tagged ] | mtu mtu-value | secondary ]
*
An MPLS L2VPN connection for a dynamic PW is configured.
NOTE
l raw and tagged are needed only for an Ethernet link.
l secondary is used to configure a backup PW. The backup PW can be configured only after the master
PW is configured. For the detailed configuration, see Configuring a Backup PW
l The combination of a PW ID and a PW type must be unique on one end of a PW, but the PW IDs on
both ends of a switch PW can be identical.
For a dynamic PW, the VC ID of the same encapsulation type should be unique. Changing
encapsulation type may cause a VC ID conflict.
----End
6.5.4 Checking the Configuration
After a dynamic PW is configured, you can view information about the PW.
Prerequisite
The configurations of the dynamic PWs function are complete.
Procedure
l Run the display mpls l2vc [ vc-id | interface interface-type interface-number ] command
to check information about a specified PW on the local PE.
l Run the display mpls l2vc remote-info [ vc-id ] command to check information about the
PW on the remote PE.
----End
Example
Run the display mpls l2vc [ vc-id | interface interface-type interface-number ] command. You
can see that VC state is up. For example:
<Quidway> display mpls l2vc interface vlanif 111
*client interface : Vlanif111 is up
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 6 PWE3 Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
559

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals