Huawei quidway s7700 - Checking the Configuration

Context
Different VPN services to the same destination on a PE must apply different tunnel policies, and
be bound with different TE tunnels.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip vpn-instance vpn-instance-name
The VPN instance view is displayed.
Step 3 Run:
tnl-policy policy-name
The tunnel policy is applied to the VPN instance.
----End
1.6.5 Checking the Configuration
After configuring L3VPN main tunnel binding, you can view information about the bound tunnel
policy, and interfaces of the bound tunnel.
Prerequisite
The configurations of the L3VPN tunnel binding function are complete.
Procedure
l Run the display tunnel-policy tunnel-policy-name command to check information about
the tunnel policy in tunnel binding mode.
l Run the display interface tunnel interface-number command to check the information
about the interface of the bound tunnel.
l Run the display ip vpn-instance verbose [ vpn-instance-name ] command to check the
tunnel policy of the VPN instance.
l Run the display ip routing-table vpn-instance vpn-instance-name [ ip-address ]
verbose command to view information about the tunnel for IP routing.
l Run the display tunnel-info tunnel-id tunnel-id command to check information about a
specified tunnel.
----End
Example
Run the display tunnel-policy command. If the bound tunnel interface is displayed, and the
destination address is configured the same as that in real situation, it means the configuration
succeeds. For example:
<Quidway> display tunnel-policy policy1
Tunnel Policy Name Destination Tunnel Intf Down Switch
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 1 VPN Tunnel Management Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
22