Huawei quidway s7700 - Page 38

---------------------------------------------------------------------
policy1 2.2.2.9 Tunnel1/0/0 Disable
3.3.3.9 Tunnel2/0/0 Disable
Run the display interface tunnel, and you can view the bound tunnel is Up. For example:
<Quidway> display interface tunnel 1/0/0
Tunnel1/0/0 current state : UP
Line protocol current state : UP
Last line protocol up time : 2009-02-23 10:54:40
Description : HUAWEI, Quidway Series, Tunnel1/0/0 Interface
Route Port,The Maximum Transmit Unit is 1500
Internet Address is unnumbered, using address of LoopBack1(1.1.1.9/32)
Encapsulation is TUNNEL, loopback not set
Tunnel destination 2.2.2.9
Tunnel up/down statistics 1
Tunnel protocol/transport MPLS/MPLS, ILM is available,
QoS max-bandwidth : 64 Kbps
Output queue : (Urgent queue : Size/Length/Discards) 0/50/0
Output queue : (Protocol queue : Size/Length/Discards) 0/1000/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
300 seconds output rate 0 bits/sec, 0 packets/sec
68 seconds output rate 0 bits/sec, 0 packets/sec
22894187 packets output, 2958834536 bytes
0 packets output error
Input bandwidth utilization : --
Output bandwidth utilization : --
Run the display ip vpn-instance verbose command. If the tunnel policy name of the VPN
instance is displayed, it means the configuration succeeds. In the following example, you can
view the tunnel policy of the VPN instance named vpna is policy1.
<Quidway> display ip vpn-instance verbose
Total VPN-Instances configured : 1
VPN-Instance Name and ID : vpna, 1
Create date : 2004/10/11 16:12:02
Up time : 0 days, 00 hours, 03 minutes and 07 seconds
Route Distinguisher : 100:1
Export VPN Targets : 100:1
Import VPN Targets : 100:1
Label Policy : label per route
Tunnel Policy : policy1
Log Interval : 5
Interfaces : Vlanif10
Run the display ip routing-table vpn-instance verbose command and you can view the tunnels
used by the VPN routes. For example:
<Quidway> display ip routing-table vpn-instance vpna 10.3.1.0 verbose
Route Flags: R - relay, D - download to fib
-----------------------------------------------------------------------------
Routing Table : vpna
Summary Count : 1
Destination: 10.3.1.0/30
Protocol: BGP Process ID: 0
Preference: 255 Cost: 0
NextHop: 2.2.2.2 Neighbour: 2.2.2.2
State: Active Adv GotQ Age: 00h00m08s
Tag: 0 Priority: low
Label: 109568 QoSInfo: 0x0
IndirectID: 0x12
RelayNextHop: 0.0.0.0 Interface: Tunnel1/0/2
Tunnel ID: 0x10002 Flags: RD
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 1 VPN Tunnel Management Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
23