l Configuring basic MPLS functions on the backbone
l Establishing tunnels between PEs based on the tunnel policy
l Setting up remote LDP sessions between PEs
Data Preparation
To configure a dynamic PW, you need the following data.
No. Data
1 Type and number of the interface connected to a CE
2 Destination address of an L2VC and VC ID
3 Policy name of the tunnel
6.5.2 Enabling MPLS L2VPN
Before configuring a dynamic PW, you must enable MPLS L2VPN.
Context
Do as follows on PEs or U-PEs:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
mpls l2vpn
MPLS L2VPN is enabled.
Before configuring an MPLS L2VC connection, enable MPLS L2VPN.
----End
6.5.3 Creating a Dynamic PW
A dynamic PW requires that IDs of the VCs with the same encapsulation type be unique. In
addition, the backup PW can be configured only after the master PW is configured.
Context
Do as follows on U-PEs:
Procedure
Step 1 Run:
system-view
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 6 PWE3 Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
558
To Next Page
Loading...
