Context
To check connectivity of a VPLS network, configure a VPLS network and do as follows on the
PE:
Procedure
l Run:
ping vpls mac mac-address vsi vsi-name [ vlan vlan-id | -c count | -m time-
value | -s packsize | -t timeout | -exp exp | -r replymode | -h ttl ]
*
Connectivity of the Layer 2 forwarding link on the VPLS network is checked.
l Run:
ping vpls [ -c echo-number | -m time-value | -s data-bytes | -t timeout-value
| -r reply-mode | -exp exp-value | -v ] * vsi vsi-name local-site-id remote-
site-id
Connectivity of the link between PEs on the Kompella VPLS network is checked.
l Run:
ping vpls [ -c echo-number | -m time-value | -s data-bytes | -t timeout-value
| -r reply-mode | -exp exp-value | -v ] * vsi vsi-name peer peer-address
[ negotiate-vc-id vc-id ]
Connectivity of the link between PEs on the Martini VPLS network is checked.
l Run:
trace vpls mac mac-address vsi vsi-name [ vlan vlan-id ] [-t timeout | -f first-
ttl | -m max-ttl | -exp exp | -r replymode ]
*
PEs and P devices along the PW on the VPLS network are displayed; connectivity of the
Layer 2 forwarding link is checked; the faulty node is located.
l Run:
tracert vpls [ -exp exp-value | -f first-ttl | -m max-ttl | -r reply-mode | -
t timeout-value ]
*
vsi vsi-name local-site-id remote-site-id [ full-lsp-path ]
Connectivity of the Kompella VPLS network is checked.
l Run:
tracert vpls [ -exp exp-value | -f first-ttl | -m max-ttl | -r reply-mode | -
t timeout-value ]
*
vsi vsi-name peer peer-address [ negotiate-vc-id vc-id ]
[ full-lsp-path ]
Connectivity of the Martini VPLS network is checked.
----End
7.13 Configuration Examples
You can learn the configuration procedures based on the configuration flowchart. Each
configuration example consists of such information as the networking requirements,
configuration notes, and configuration roadmap.
7.13.1 Example for Configuring Martini VPLS
Networking Requirements
As shown in Figure 7-12, VPLS needs to be enabled on PE1 and PE2; CE1 is connected to PE1
and CE2 is connected to PE2; CE1 and CE2 belong to the same VPLS network; PWs are
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
730
To Next Page
Loading...
