Huawei quidway s7700 - Configuring a UPE to Access an SPE through a Static VLL; Configuring the UPE to Access the SPE through the Static VLL

No. Data
4 ID of the destination LSR of the static VLL
5 Received and sent label of the static VLL
6 Tunnel policy of the static VLL
7.6.2 Configuring a UPE to Access an SPE Through a Static VLL
Context
Do as follows on the UPE.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Enter the interface view.
Step 3 Run:
interface interface-type interface-number
The interface view is displayed.
Step 4 (Optional) Run:
undo portswitch
The Layer 2 interface is configured as a Layer 3 interface.
NOTE
To use an XGE interface, a GE interface, an Ethernet interface, or an Eth-Trunk interface of the S7700 as
the AC interface of the PE, you need to run undo portswitch to configure the Layer 2 interface as a Layer
3 interface.
Step 5 Run:
mpls static-l2vc destination ip-address transmit-vpn-label transmit-label-value
receive-vpn-label receive-label-value [ tunnel-policy tnl-policy-name | [ control-
word | no-control-word ] | [ raw | tagged ] ]
*
A static VC is created between the UPE and the SPE.
----End
7.6.3 Configuring the UPE to Access the SPE Through the Static VLL
This section describes how to configure a static VLL on a UPE, specifying the peer as an SPE.
Context
Do as follows on the UPE:
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
701