Loopback1 - 3.3.3.9/32
UPE2 GigabitEthernet 1/0/0 VLANIF 50 100.1.4.2/24
GigabitEthernet 2/0/0 VLANIF 60 -
Loopback1 - 5.5.5.9/32
CE1 GigabitEthernet 1/0/0 VLANIF 10 10.1.1.1/24
CE2 GigabitEthernet 1/0/0 VLANIF 60 10.1.1.2/24
Configuration Roadmap
The configuration roadmap is as follows:
1. Complete the task of Configuring Martini VPLS between SPEs.
2. Configure basic MPLS L2VPN functions on UPEs and SPEs.
3. Configure static VLLs and VSIs on SPEs and enable MAC-withdraw function on the VSIs.
4. Configure UPEs to access SPEs through static VLLs.
Data Preparation
To complete the configuration, you need the following data:
l Names and IDs of VSIs
l MPLS LSR IDs of UPEs and SPEs, which are used as peer IP addresses
l Routing protocol
l Received and sent labels on static LSPs between UPEs and SPEs
Procedure
1. Configure IP addresses for interfaces.
As shown in Figure 7-16, configure the VLAN to which each interface belongs, and
configure the IP addresses and masks for loopback interfaces and VLANIF interfaces. The
details are not mentioned here.
NOTE
Do not add the AC-side port and PW-side port of a PE to the same VLAN; otherwise, a loop may
occur.
2. Configure an IGP.
Configure OSPF on SPEs and the P device to advertise the network segment and LSR IDs.
# Configure SPE1.
<SPE1> system-view
[SPE1] ospf
[SPE1-ospf-1] area 0
[SPE1-ospf-1-area-0.0.0.0] network 1.1.1.9 0.0.0.0
[SPE1-ospf-1-area-0.0.0.0] network 100.1.1.0 0.0.0.255
[SPE1-ospf-1-area-0.0.0.0] network 100.1.3.0 0.0.0.255
[SPE1-ospf-1-area-0.0.0.0] quit
[SPE1-ospf-1] quit
# Configure P.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
762
To Next Page
Loading...
