EasyManua.ls Logo

Huawei quidway s7700 - Page 229

Huawei quidway s7700
833 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
[Hub-PE] interface vlanif 40
[Hub-PE-Vlanif40] ip binding vpn-instance vpn_out
[Hub-PE-Vlanif40] ip address 110.2.1.2 24
[Hub-PE-Vlanif40] quit
# Configure the IP addresses of the interfaces on the CEs. The configuration procedure is not
given here.
After the configuration, run the display ip vpn-instance verbose command on the PEs, and you
can see the configuration of the VPN instances. Each PE can ping the connected CEs by using
the ping -vpn-instance vpn-name ip-address command.
NOTE
If multiple interfaces on a PE are bound to the same VPN, you must specify the source address when you
run the ping -vpn-instance command to ping the CE connected to the peer PE. That is, specify -a source-
ip-address in the ping -vpn-instance vpn-instance-name -a source-ip-address destination-address
command. Otherwise, the ping operation may fail.
Step 4 Set up EBGP peer relation between the PE and the CE and import VPN routes.
NOTE
To receive the routes advertised by the Hub-CE, configure the Hub-PE to allow the ASN to be repeated
once.
# Configure Spoke-CE1.
[Spoke-CE1] bgp 65410
[Spoke-CE1-bgp] peer 100.1.1.2 as-number 100
[Spoke-CE1-bgp] import-route direct
[Spoke-CE1-bgp] quit
# Configure Spoke-PE1.
[Spoke-PE1] bgp 100
[Spoke-PE1-bgp] ipv4-family vpn-instance vpna
[Spoke-PE1-bgp-vpna] peer 100.1.1.1 as-number 65410
[Spoke-PE1-bgp-vpna] import-route direct
[Spoke-PE1-bgp-vpna] quit
[Spoke-PE1-bgp] quit
# Configure Spoke-CE2.
[Spoke-CE2] bgp 65420
[Spoke-CE2-bgp] peer 120.1.1.2 as-number 100
[Spoke-CE2-bgp] import-route direct
[Spoke-CE2-bgp] quit
# Configure Spoke-PE2.
[Spoke-PE2] bgp 100
[Spoke-PE2-bgp] ipv4-family vpn-instance vpna
[Spoke-PE2-bgp-vpna] peer 120.1.1.1 as-number 65420
[Spoke-PE2-bgp-vpna] import-route direct
[Spoke-PE2-bgp-vpna] quit
[Spoke-PE2-bgp] quit
# Configure the Hub-CE.
[Hub-CE] bgp 65430
[Hub-CE-bgp] peer 110.1.1.2 as-number 100
[Hub-CE-bgp] peer 110.2.1.2 as-number 100
[Hub-CE-bgp] import-route direct
[Hub-CE-bgp] quit
# Configure the Hub-PE.
[Hub-PE] bgp 100
[Hub-PE-bgp] ipv4-family vpn-instance vpn_in
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 3 BGP MPLS IP VPN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
214

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals