Huawei quidway s7700 - Page 241

192.1.1.1/32 Direct 0 0 D 127.0.0.1 InLoopBack0
192.1.1.255/32 Direct 0 0 D 127.0.0.1 InLoopBack0
255.255.255.255/32 Direct 0 0 D 127.0.0.1 InLoopBack0
Run the display bgp vpnv4 all routing-table command on an ASBR-PE, and you can see the
VPNv4 routes on the ASBR-PE.
[ASBR-PE1] display bgp vpnv4 all routing-table
BGP Local router ID is 2.2.2.9
Status codes: * - valid, > - best, d - damped,
h - history, i - internal, s - suppressed, S - Stale
Origin : i - IGP, e - EGP, ? - incomplete
Total number of routes from all PE: 2
Route Distinguisher: 100:1
Network NextHop MED LocPrf PrefVal Path/Ogn
*>i 10.1.1.0/24 1.1.1.9 0 100 0 ?
*>i 10.1.1.1/32 1.1.1.9 0 100 0 ?
Total routes of vpn-instance vpn1: 9
Network NextHop MED LocPrf PrefVal Path/Ogn
*>i 10.1.1.0/24 1.1.1.9 0 100 0 ?
*>i 10.1.1.1/32 1.1.1.9 0 100 0 ?
*> 10.2.1.0/24 192.1.1.2 0 200?
*> 10.2.1.1/32 192.1.1.2 0 200?
*> 192.1.1.0 0.0.0.0 0 0 ?
* 192.1.1.2 0 0 200?
*> 192.1.1.1/32 0.0.0.0 0 0 ?
* 192.1.1.2 0 0 200?
*> 192.1.1.2/32 0.0.0.0 0 0 ?
----End
Configuration Files
l Configuration file of CE1
#
sysname CE1
#
vlan batch 10
#
interface Vlanif 10
ip address 10.1.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 10
#
bgp 65001
peer 10.1.1.2 as-number 100
#
ipv4-family unicast
undo synchronization
import-route direct
peer 10.1.1.2 enable
#
return
l Configuration file of PE1
#
sysname PE1
#
vlan batch 10 20
#
ip vpn-instance vpn1
route-distinguisher 100:1
vpn-target 1:1 export-extcommunity
vpn-target 1:1 import-extcommunity
#
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 3 BGP MPLS IP VPN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
226