EasyManua.ls Logo

Huawei quidway s7700 - Page 296

Huawei quidway s7700
833 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
[PE3] ip vpn-instance vpn1
[PE3-vpn-instance-vpn1] route-distinguisher 100:3
[PE3-vpn-instance-vpn1] vpn-target 1:1 both
[PE3-vpn-instance-vpn1] quit
# Bind the interfaces connected to CEs to the corresponding VPNs and assign IP addresses to
these interfaces.
[PE3] interface vlanif 103
[PE3-Vlanif103] ip binding vpn-instance vpn1
[PE3-Vlanif103] ip address 10.3.1.1 30
[PE3-Vlanif103] quit
# Configure PE4.
# Create a VPN instance and specify the RD and VPN target. The VPN targets of PE4 and the
MP-BGP peer PE to implement mutual access of sites on the same VPN.
[PE4] ip vpn-instance vpn1
[PE4-vpn-instance-vpn1] route-distinguisher 100:4
[PE4-vpn-instance-vpn1] vpn-target 1:1 both
[PE4-vpn-instance-vpn1] quit
# Bind the interfaces connected to CEs to the corresponding VPNs and assign IP addresses to
these interfaces.
[PE4] interface vlanif 104
[PE4-Vlanif104] ip binding vpn-instance vpn1
[PE4-Vlanif104] ip address 10.4.1.1 30
[PE4-Vlanif104] quit
# Assign IP addresses to the interfaces on CEs according to Figure 3-15. The configuration
details are not mentioned here.
# After the configuration, run the display ip vpn-instance verbose command on PEs, and you
can view configuration results of VPN instances.
For example, information about PE1 is displayed as follows:
<PE1> display ip vpn-instance verbose
Total VPN-Instances configured : 1
VPN-Instance Name and ID : vpn1, 1
Create date : 2006/10/14 18:12:43 UTC-08:00
Up time : 0 days, 01 hours, 56 minutes and 16 seconds
Route Distinguisher : 100:1
Export VPN Targets : 1:1
Import VPN Targets : 1:1
Label policy : label per route
Log Interval : 5
Interfaces : Vlanif101
Step 5 Configure EBGP between PEs and CEs to import VPN routes.
# Configure CE1.
# Enable BGP, specify PE1 and PE2 as EBGP peers, and import direct routes.
[CE1] bgp 65410
[CE1-bgp] peer 10.1.1.2 as-number 100
[CE1-bgp] peer 10.2.1.2 as-number 100
[CE1-bgp] import-route direct
[CE1-bgp] quit
# Configure PE1.
# Enable BGP.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 3 BGP MPLS IP VPN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
281

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals