Huawei quidway s7700 - Page 33

Procedure
l Run the display tunnel-policy tunnel-policy-name. command to check the configuration
of a tunnel policy.
l Run the display mpls l2vc [ interface interface-type interface-number ]. command to check
the information about the tunnel used by the VC in L2VPN in SVC, PWE3, or Martini
mode.
l Run the display mpls l2vpn connection [ interface interface-type interface-number ]
command to check the information about the tunnel used by the VC in Kompella L2VPN.
l Run the display tunnel-info tunnel-id tunnel-id command to check information about a
specified tunnel.
----End
Example
Run the display tunnel-policy command. If the bound tunnel interface is displayed, it means
the configuration succeeds. For example:
<Quidway> display tunnel-policy policy1
Tunnel Policy Name Select-Seq Load balance No
---------------------------------------------------------------------
policy1 LSP 1
For the VC of the L2VPN in SVC or Martini mode, run the display mpls l2vc interface
interface-type interface-number command. If the tunnel policy configuration of the VC is
displayed, it means the configuration succeeds. In the following example, you can view the
tunnel policy on VLANIF 10 of the VC is policy1.
<Quidway> display mpls l2vc interface vlanif 10
*client interface : Vlanif10 is up
Administrator PW : no
session state : up
AC state : up
VC state : up
VC ID : 116119
VC type : VLAN
destination : 6.6.6.6
local group ID : 0 remote group ID : 0
local VC label : 23552 remote VC label : 23552
local AC OAM State : up
local PSN State : up
local forwarding state : forwarding
local status code : 0x0
remote AC OAM state : up
remote PSN state : up
remote forwarding state: forwarding
remote status code : 0x0
BFD for PW : unavailable
manual fault : not set
active state : active
forwarding entry : exist
link state : up
local VC MTU : 1500 remote VC MTU : 1500
local VCCV : alert lsp-ping bfd
remote VCCV : Disable
local control word : disable remote control word : disable
tunnel policy name : policy1
traffic behavior name : --
PW template name : --
primary or secondary : primary
VC tunnel/token info : 1 tunnels/tokens
NO.0 TNL type : lsp , TNL ID : 0x10000
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 1 VPN Tunnel Management Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
18