The configuration of PE2 is similar to the configuration of PE1, and is not mentioned.
After the configuration, run the display bgp vpnv6 all peer command on the PEs, and you
can see that the IBGP peer relation is set up between the PEs and RR and is in Established
state. The EBGP relation is set up between the PE and CEs.
Take the display on PE1 and RR as an example.
<PE1> display bgp vpnv6 all peer
 BGP local router ID : 1.1.1.9
 Local ASN : 100
 Total number of peers : 2                 Peers in established state : 2
  Peer            V    AS  MsgRcvd  MsgSent  OutQ  Up/Down       State PrefRcv
  2.2.2.9         4   100       15       17     0 00:13:11 Established       0
  Peer of vpn6 instance :
  vpn6 instance VPNA :
  2001::1         4 65410        9       10     0 00:06:41 Established       0
6. Enable the route reflection function on the RR.
# Configure RR.
[RR] bgp 100
[RR-bgp] ipv6-family vpnv6
[RR-bgp-af-vpnv6] reflector cluster-id 100
[RR-bgp-af-vpnv6] peer 1.1.1.9 reflect-client
[RR-bgp-af-vpnv6] peer 3.3.3.9 reflect-client
[RR-bgp-af-vpnv6] undo policy vpn-target
[RR-bgp-af-vpnv6] quit
7. Verify the configuration.
Display the VPN routing table on a PE, and you can see the route to the remote CE.
Take the display on PE1 as an example.
<PE1> display ipv6 routing-table vpn6-instance VPNA
Routing Table : VPNA
         Destinations : 4        Routes : 4
 Destination  : 2001::                                  PrefixLength : 64
 NextHop      : 2001::2                                 Preference   : 0
 Interface    : Vlanif30                                Protocol     : Direct
 State        : Active Adv                              Cost         : 0
 Tunnel ID    : 0x0                                     Label        : NULL
 Age          : 10936sec
 Destination  : 2001::2                                 PrefixLength : 128
 NextHop      : ::1                                     Preference   : 0
 Interface    : InLoopBack0                             Protocol     : Direct
 State        : Active NoAdv                            Cost         : 0
 Tunnel ID    : 0x0                                     Label        : NULL
 Age          : 10936sec
 Destination  : 2002::                                  PrefixLength : 64
 NextHop      : ::FFFF:3.3.3.9                          Preference   : 255
 Interface    : NULL0                                   Protocol     : BGP
 State        : Active Adv GotQ                         Cost         : 0
 Tunnel ID    : 0x6002d20                               Label        : 15360
 Age          : 1753sec
 Destination  : FE80::                                  PrefixLength : 10
 NextHop      : ::                                      Preference   : 0
 Interface    : NULL0                                   Protocol     : Direct
 State        : Active NoAdv                            Cost         : 0
 Tunnel ID    : 0x0                                     Label        : NULL
 Age          : 10940sec
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 4 BGP MPLS IPv6 VPN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
441