Huawei quidway s7700 - Page 549

manual fault set or not: not set
AC OAM state: up
BFD for PW session index: --
BFD for PW state: invalid
BFD for LSP state: true
Local C bit is not set
Remote C bit is not set
tunnel type: lsp
tunnel id: 0x10002
# The display on ASBR-PE2 is as follows:
<ASBR-PE2> display mpls l2vpn connection interface vlanif 30
conn-type: remote
local vc state: up
remote vc state: up
local ce-id: 3
local ce name: ce3
remote ce-id: 4
intf(state,encap): Vlanif30(up,vlan)
peer id: 4.4.4.4
route-distinguisher: 200:2
local vc label: 31746
remote vc label: 35853
tunnel policy: default
CKey: 19
NKey: 3
primary or secondary: primary
forwardEntry exist or not: true
forward entry active or not:true
manual fault set or not: not set
AC OAM state: up
BFD for PW session index: --
BFD for PW state: invalid
BFD for LSP state: true
Local C bit is not set
Remote C bit is not set
tunnel type: lsp
tunnel id: 0x10001
CE1 and CE2 can ping each other.
<CE1> ping 10.1.1.2
PING 10.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 10.1.1.2: bytes=56 Sequence=1 ttl=255 time=125 ms
Reply from 10.1.1.2: bytes=56 Sequence=2 ttl=255 time=125 ms
Reply from 10.1.1.2: bytes=56 Sequence=3 ttl=255 time=94 ms
Reply from 10.1.1.2: bytes=56 Sequence=4 ttl=255 time=125 ms
Reply from 10.1.1.2: bytes=56 Sequence=5 ttl=255 time=125 ms
--- 10.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 94/118/125 ms
----End
Configuration Files
l Configuration file of CE1
#
sysname CE1
#
vlan batch 10
#
interface Vlanif10
ip address 10.1.1.1 255.255.255.0
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 5 VLL Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
534