EasyManua.ls Logo

Huawei quidway s7700 - Page 577

Huawei quidway s7700
833 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
l Static PWs switching: Both PWs used to switch are static.
l Dynamic PWs switching: Both PWs used to switch are dynamic.
l Mixed PWs switching: One of the PWs is dynamic, and the other is static.
Procedure
l Static PW Switching
Do as follows on the S-PEs.
1. Run:
system-view
The system view is displayed.
2. Run:
mpls switch-l2vc ip-address vc-id trans trans-label recv received-label
between ip-address vc-id trans trans-label recv received-label
encapsulation encapsulation-type [ control-word [ cc { alert | cw } * cv
lsp-ping ] | [ no-control-word ] [ cc alert cv lsp-ping ] ]
The static PWs switching is enabled.
A PW label must be manually configured on the S-PE for static PW switching.
The conditions of setting up a static MH-PW are as follows:
On U-PE, once the AC state is up and PSN tunnel exists, the PW state is up.
On the S-PE, once the PSN tunnels on both sides exist, the PW is in up state. This
is regardless of whether the PW encapsulation of S-PE is consistent with that of
U-PE or not.
For the sake of management convenience, it is recommended to configure the same
PW encapsulation type on the devices along the PW (U-PE and S-PE).
l Dynamic PW Switching
Do as follows on the S-PEs.
1. Run:
system-view
The system view is displayed.
2. Run:
mpls switch-l2vc ip-address vc-id between ip-address vc-id encapsulation
encapsulation-type [ control-word-transparent ]
The dynamic PWs switching is configured.
When configuring dynamic PW switching, ensure that the PW encapsulation type is
consistent on the devices (U-PE and S-PE) along the PW; otherwise, the PW will not
enter the Up state.
l Mixed PW Switching
NOTE
While configuring mixed PWs switching, note that the parameters "ip-address" and "vc-id" before
"between" in the command are that of dynamic PW, while the ones after "between" are that of static
PW. Both these cannot be interchanged.
Do as follows on the S-PEs.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 6 PWE3 Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
562

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals