EasyManua.ls Logo

Huawei quidway s7700 - Page 612

Huawei quidway s7700
833 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
[U-PE1-pw-template-pwt] quit
[U-PE1] mpls l2vpn
[U-PE1-l2vpn] quit
[U-PE1] interface vlanif 10
[U-PE1-Vlanif10] mpls static-l2vc pw-template pwt 100 transmit-vpn-label 100
receive-vpn-label 100
[U-PE1-Vlanif10] quit
# Configure S-PE.
[S-PE] mpls l2vpn
[S-PE-l2vpn] quit
[S-PE] mpls switch-l2vc 5.5.5.9 100 trans 200 recv 200 between 1.1.1.9 100 trans
100 recv 100 encapsulation vlan
# Configure U-PE2.
[U-PE2] mpls l2vpn
[U-PE2-l2vpn] quit
[U-PE2] pw-template pwt
[U-PE2-pw-template-pwt] peer-address 3.3.3.9
[U-PE2-pw-template-pwt] quit
[U-PE2] interface vlanif 60
[U-PE2-Vlanif60] mpls static-l2vc pw-template pwt 100 transmit-vpn-label 200
receive-vpn-label 200
[U-PE2-Vlanif60] quit
NOTE
The transmit-vpn-label set on the U-PE must be consistent with the recv label on the S-PE; the receive-
vpn-label set on the U-PE must be consistent with the trans label on the S-PE. Otherwise, CEs cannot
communicate with each other.
Step 5 Verify the configuration.
View information about the L2VPN connection on the PEs, and you can see that an L2VC is set
up and is in Up state.
Take U-PE1 and S-PE for example.
<U-PE1> display mpls static-l2vc interface vlanif 10
*Client Interface : Vlanif10 is up
AC Status : up
VC State : up
VC ID : 100
VC Type : VLAN
Destination : 3.3.3.9
Transmit VC Label : 100
Receive VC Label : 100
Control Word : Disable
VCCV Capabilty : alert lsp-ping bfd
Tunnel Policy : --
PW Template Name : pwt
Traffic Behavior : --
Main or Secondary : Main
VC tunnel/token info : 1 tunnels/tokens
NO.0 TNL Type : lsp , TNL ID : 0x4800200f
Create time : 0 days, 0 hours, 13 minutes, 7 seconds
UP time : 0 days, 0 hours, 10 minutes, 23 seconds
Last change time : 0 days, 0 hours, 10 minutes, 23 seconds
VC last up time : 2010/11/14 12:31:31
VC total up time : 0 days, 2 hours, 12 minutes, 51 seconds
CKey : 2
NKey : 3
<S-PE> display mpls switch-l2vc
Total Switch VC : 1, 1 up, 0 down
*Switch-l2vc type : SVC<---->SVC
Peer IP Address : 5.5.5.9, 1.1.1.9
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 6 PWE3 Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
597

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals