Huawei quidway s7700 - Page 657

manual fault : not set
active state : active
forwarding entry : exist
link state : up
local VC MTU : 4470 remote VC MTU : 4470
local VCCV : cw alert lsp-ping bfd
remote VCCV : cw alert lsp-ping bfd
local control word : enable remote control word : enable
tunnel policy : --
traffic behavior : --
PW template name : 1to2
primary or secondary : primary
VC tunnel/token info : 1 tunnels/tokens
NO.0 TNL type : lsp , TNL ID : 0x4800200f
create time : 0 days, 0 hours, 6 minutes, 43 seconds
up time : 0 days, 0 hours, 5 minutes, 43 seconds
last change time : 0 days, 0 hours, 5 minutes, 43 seconds
VC last up time : 2010-11-24 14:33:31
VC total up time : 0 days, 2 hours, 11 minutes, 55 seconds
CKey : 16
NKey : 15
PW redundancy mode : --
AdminPw interface : --
AdminPw link state : --
# Run the display bfd session all verbose command on PE to view the status of the BFD session.
You can find that the BFD session is Up, the BFD session is bound to a PW, and the type of the
BFD session is dynamic.
Take the display on PE1 for example.
<PE1> display bfd session all verbose
--------------------------------------------------------------------------------
Session MIndex : 256 (One Hop) State : Up Name : dyn_8192
--------------------------------------------------------------------------------
Local Discriminator : 8192 Remote Discriminator : 8192
Session Detect Mode : Asynchronous Mode Without Echo Function
BFD Bind Type : PW(Master)
Bind Session Type : Dynamic
Bind Peer Ip Address : --.--.--.--
NextHop Ip Address : --.--.--.--
Bind Interface : Vlanif10
FSM Board Id : 1 TOS-EXP : 6
Min Tx Interval (ms) : 100 Min Rx Interval (ms) : 100
Actual Tx Interval (ms): 100 Actual Rx Interval (ms): 100
Local Detect Multi : 3 Detect Interval (ms) : 300
Echo Passive : Disable Acl Number : --
Proc interface status : Disable Process PST : Enable
WTR Interval (ms) : -- Local Demand Mode : Disable
Active Multi : 3
Last Local Diagnostic : No Diagnostic
Bind Application : L2VPN | OAM_MANAGER | MPLSFW
Session TX TmrID : -- Session Detect TmrID : --
Session Init TmrID : -- Session WTR TmrID : --
Session Echo Tx TmrID : --
PDT Index : FSM-0 | RCV-0 | IF-0 | TOKEN-0
Session Description : --
--------------------------------------------------------------------------------
----End
Configuration Files
l Configuration file of CE1
#
sysname CE1
#
vlan batch 10
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 6 PWE3 Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
642