Huawei quidway s7700 - Page 66

# Check information about the interfaces on the bound tunnel.
# Take Tunnel 1/0/0 of PE1 as an example.
[PE1-Tunnel1/0/0] display this interface
Tunnel1/0/0 current state : UP
Line protocol current state : UP
Last line protocol up time : 2007-09-10 13:54:57-08:00
Description:HUAWEI, Quidway Series, Tunnel1/0/0 Interface
Route Port,
Internet Address is unnumbered, using address of LoopBack1(1.1.1.9/32)
Encapsulation is TUNNEL, loopback not set
Tunnel destination 2.2.2.9
Tunnel up/down statistics 1
Tunnel protocol/transport MPLS/MPLS, ILM is available,
primary tunnel id is 0x1003c, secondary tunnel id is 0x0
QoS max-bandwidth : 64 Kbps
Output queue : (Urgent queue : Size/Length/Discards) 0/50/0
Output queue : (Protocol queue : Size/Length/Discards) 0/1000/0
Output queue : (FIFO queue : Size/Length/Discards) 0/256/0
300 seconds output rate 0 bits/sec, 0 packets/sec
190 seconds output rate 0 bits/sec, 0 packets/sec
0 packets output, 0 bytes
0 output error
0 output drop
Input bandwidth utilization : --
Output bandwidth utilization : --
# CE1 can ping CE2 and CE3.
# Display information about Tunnel1/0/0 on PE1.
[PE1] display interface Tunnel 1/0/0
Tunnel1/0/0 current state : UP
Line protocol current state : UP
Last line protocol up time : 2007-09-10 13:54:57-08:00
Description:HUAWEI, Quidway Series, Tunnel1/0/0 Interface
Route Port,
Internet Address is unnumbered, using address of LoopBack1(1.1.1.9/32)
Encapsulation is TUNNEL, loopback not set
Tunnel destination 2.2.2.9
Tunnel up/down statistics 1
Tunnel protocol/transport MPLS/MPLS, ILM is available,
primary tunnel id is 0x1003c, secondary tunnel id is 0x0
QoS max-bandwidth : 64 Kbps
Output queue : (Urgent queue : Size/Length/Discards) 0/50/0
Output queue : (Protocol queue : Size/Length/Discards) 0/1000/0
Output queue : (FIFO queue : Size/Length/Discards) 0/256/0
300 seconds output rate 2952 bits/sec, 2 packets/sec
196 seconds output rate 72 bits/sec, 0 packets/sec
48739720 packets output, 361150 bytes
0 output error
0 output drop
Input bandwidth utilization : --
Output bandwidth utilization : --
# You can see that the number of datagrams passing through Tunnel 1/0/0 increases.
# Run the ping 20.1.1.2 command on CE1 to check information about Tunnel 1/0/0 of PE1. You
can see that the statistics of packets on Tunnel 1/0/0 remain unchanged because Tunnel 1/0/0
on PE1 transmits only the data between PE1 and PE2.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 1 VPN Tunnel Management Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
51