When deploying VPLS in a larger scope, PEs or CEs may belong to different ASs. In such a
situation, you cannot directly establish PWs between PEs based on LDP. To address the problem,
you can configure inter-AS LDP VPLS.
7.9 Configuring Dual-homed Kompella VPLS
This section describes how to configure dual-homed Kompella VPLS. After dual-homed
Kompella VPLS is configured, VPLS reliability is enhanced, and thus preventing faults on each
PE.
7.10 Configuring Related Parameters of a VSI
This section describes how to set or adjust general VPLS parameters.
7.11 Configuring Suppression on VPLS Traffic
This section describes how to suppress the broadcast, multicast, and unknown unicast traffic on
the VPLS network.
7.12 Maintaining VPLS
Maintaining VPLS involves collecting, viewing, and clearing VPLS PW traffic statistics,
checking consistency of VPN configurations, enabling/disabling VSIs, clearing MAC address
entries, diagnosing MAC address learning capacity, detecting the forwarding process of VPLS
multicast traffic, checking the VPLS network connectivity, and detecting IP addresses.
7.13 Configuration Examples
You can learn the configuration procedures based on the configuration flowchart. Each
configuration example consists of such information as the networking requirements,
configuration notes, and configuration roadmap.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
668
To Next Page
Loading...
