3. (Optional) Run:
undo portswitch
The Layer 2 interface is configured as a Layer 3 interface.
4. Run:
l2 binding vsi vsi-name
The VSI is bound to the Ethernet interface.
l Bind a VSI to a VLANIF interface.
Do as follows on the PEs at both ends of a PW:
1. Run:
system-view
The system view is displayed.
2. Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
3. Run:
l2 binding vsi vsi-name
The VLANIF interface is bound to the VSI.
NOTE
Do not configure VSI and VLAN mapping for the same VLAN on an interface; otherwise,
either VSI or VLAN mapping will take effect.
l Bind a VSI to an Eth-Trunk interface.
Do as follows on the PEs at both ends of a PW:
1. Run:
system-view
The system view is displayed.
2. Run:
interface eth-trunk trunk-id
An Eth-Trunk interface is created.
3. Run:
quit
Return to the system view.
4. Run:
interface { ethernet | gigabitethernet | xgigabitethernet } interface-
number
The view of the interface to be added into the Eth-Trunk is displayed.
An Eth-Trunk member interface cannot be configured with a static MAC address.
NOTE
Member interfaces of a trunk cannot be Eth-Trunk interfaces.
5. Run:
eth-trunk trunk-id
The interface is added into the Eth-Trunk.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
694
To Next Page
Loading...
