Example
Run the display vsi [ name vsi-name ] [ verbose ] command. You can view that the item "VSI
State" is displayed as "up". If verbose is selected, the item "Signaling" is displayed as "ldp" and
the item "VC State" is displayed as "up". This means that the configuration succeeds. For
example:
<Quidway> display vsi name a2 verbose
***VSI Name : a2
Administrator VSI : no
Isolate Spoken : disable
VSI Index : 0
PW Signaling : ldp
Member Discovery Style : static
PW MAC Learn Style : unqualify
Encapsulation Type : vlan
MTU : 1500
Diffserv Mode : uniform
Mpls Exp : --
DomainId : 255
Domain Name :
Ignore AcState : disable
Multicast Fast Swicth : disable
Create Time : 0 days, 3 hours, 30 minutes, 31 seconds
VSI State : up
......
Run the display vsi remote ldp [ router-id ip-address ] [ pw-id pw-id ] command. If information
about the remote VSI established through LDP is displayed, it means that the configuration
succeeds. For example:
<Quidway> display vsi remote ldp
Vsi Peer VC Group Encap MTU Vsi
ID RouterID Label ID Type Value Index
2 3.3.3.9 23552 0 vlan 1500 0
Run the display vpls connection [ ldp | vsi vsi-name ] [ down | up ] [ verbose ] command. You
can view that the item "VC State" is displayed as "up". If verbose is selected, the item "Signaling"
is displayed as "ldp", the item "VC State" is displayed as "up", and label allocation is complete.
For example:
<Quidway> display vpls connection ldp verbose
VSI Name: a2 Signaling: ldp
**Remote Vsi ID : 2
VC State : up
Encapsulation : vlan
Group ID : 0
MTU : 1500
Peer Ip Address : 3.3.3.9
PW Type : label
Local VC Label : 27648
Remote VC Label : 27648
Tunnel Policy : --
Tunnel ID : 0x10002,
Run the ping vpn-config peer-address peer-address vsi-name vsi-name [ pw-id pw-id ]
[ local ] [ remote ] command. You can view configurations of the VSI on the local and peer
PEs, which include information about the VSI type, VSI description, VSI management status,
VSI operation status, PW status, MTU value, number of AC in the VSI, IP address of the peer
PE, IP address of the local PE, whether probe or Echo Reply packets are forwarded through the
LSP tunnel, PW-ID, PE types, VC encapsulation type, and outer incoming and outgoing tags.
<Quidway> ping vpn-config peer-address 6.6.6.6 vsi-name ldpvpls pw-id 119 local
remote
VPN-CONFIG PING: Prese CTRL_C to break.
Result Detail: Request Sent - Reply Received
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
696
To Next Page
Loading...
