Step 4 Enable MPLS L2VPN and configure a VSI.
# Configure the UPE.
<UPE> system-view
[UPE] mpls l2vpn
[UPE] vsi v123 static
[UPE-vsi-v123] pwsignal ldp
[UPE-vsi-v123-ldp] vsi-id 123
[UPE-vsi-v123-ldp] peer 2.2.2.9
# Configure the SPE.
<SPE> system-view
[SPE] mpls l2vpn
[SPE] vsi v123 static
[SPE-vsi-v123] pwsignal ldp
[SPE-vsi-v123-ldp] vsi-id 123
[SPE-vsi-v123-ldp] peer 3.3.3.9
[SPE-vsi-v123-ldp] peer 1.1.1.9 upe
# Configure the PE.
<PE> system-view
[PE] mpls l2vpn
[PE] vsi v123 static
[PE-vsi-v123] pwsignal ldp
[PE-vsi-v123-ldp] vsi-id 123
[PE-vsi-v123-ldp] peer 2.2.2.9
Step 5 Bind VSIs to interfaces on the SPE and UPE.
# Configure the UPE.
[UPE] interface vlanif 10
[UPE-Vlanif10] l2 binding vsi v123
[UPE-Vlanif10] quit
[UPE] interface vlanif 20
[UPE-Vlanif20] l2 binding vsi v123
[UPE-Vlanif20] quit
# Configure the PE.
[PE] interface vlanif 50
[PE-Vlanif50] l2 binding vsi v123
Step 6 Assign an IP address to each VLANIF interface on CEs.
# Configure CE1.
<Quidway> sysname CE1
[CE1] interface vlanif 10
[CE1-Vlanif10] ip address 10.1.1.1 255.255.255.0
# Configure CE2.
<Quidway> sysname CE2
[CE2] interface vlanif 20
[CE2-Vlanif20] ip address 10.1.1.2 255.255.255.0
# Configure CE3.
<Quidway> sysname CE3
[CE3] interface vlanif 50
[CE3-Vlanif50] ip address 10.1.1.3 255.255.255.0
Step 7 Verify the configuration.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
756
To Next Page
Loading...
