[ASBR-PE1-vsi-a1-ldp] vsi-id 2
[ASBR-PE1-vsi-a1-ldp] peer 1.1.1.1
[ASBR-PE1-vsi-a1-ldp] quit
[ASBR-PE1-vsi-a1] quit
[ASBR-PE1] interface vlanif 30
[ASBR-PE1-Vlanif30] l2 binding vsi a1
[ASBR-PE1-Vlanif30] quit
# Configure ASBR-PE2.
[ASBR-PE2] vsi a1 static
[ASBR-PE2-vsi-a1] pwsignal ldp
[ASBR-PE2-vsi-a1-ldp] vsi-id 3
[ASBR-PE2-vsi-a1-ldp] peer 4.4.4.4
[ASBR-PE2-vsi-a1-ldp] quit
[ASBR-PE2-vsi-a1] quit
[ASBR-PE2] interface vlanif 30
[ASBR-PE2-Vlanif30] l2 binding vsi a1
[ASBR-PE2-Vlanif30] quit
# Configure PE2.
[PE2] vsi a1 static
[PE2-vsi-a1] pwsignal ldp
[PE2-vsi-a1-ldp] vsi-id 3
[PE2-vsi-a1-ldp] peer 3.3.3.3
[PE2-vsi-a1-ldp] quit
[PE2-vsi-a1] quit
[PE2] interface vlanif 50
[PE2-Vlanif50] l2 binding vsi a1
[PE2-Vlanif50] quit
Step 6 Configure CEs.
# Configure CE1.
[CE1] interface vlanif 10
[CE1-Vlanif10] ip address 10.1.1.1 24
[CE1-Vlanif10] quit
# Configure CE2.
[CE2] interface vlanif 50
[CE2-Vlanif50] ip address 10.1.1.2 24
[CE2-Vlanif50] quit
Step 7 Verify the configuration.
After the preceding configurations, run the display vsi name verbose command on PE1. You
can find that a VSI named a1 sets up a PW to PE2, and the status of the VSI is UP.
<PE1> display vsi name a1 verbose
***VSI Name : a1
Administrator VSI : no
Isolate Spoken : disable
VSI Index : 0
PW Signaling : ldp
Member Discovery Style : static
PW MAC Learn Style : unqualify
Encapsulation Type : vlan
MTU : 1500
Diffserv Mode : uniform
Mpls Exp : --
DomainId : 0
Domain Name :
Ignore AcState : disable
Create Time : 0 days, 3 hours, 30 minutes, 31 seconds
VSI State : up
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
784
To Next Page
Loading...
