Huawei quidway s7700 - Page 809

Run the display bgp vpls all command on a PE or an ASBR-PE, and you can view information
about the VPLS label block of BGP.
Take ASBR-PE1 as an example.
<ASBR-PE1> display bgp vpls all
BGP Local Router ID : 2.2.2.2, Local AS Number : 100
Status codes : * - active, > - best
BGP.VPLS : 2 Label Blocks
--------------------------------------------------------------------------------
Route Distinguisher: 100:1
SiteID Offset NextHop Range LabBase TunnelID FromPeer MHPref
--------------------------------------------------------------------------------
*> 1 0 1.1.1.1 5 31744 0x0 1.1.1.1 0
--------------------------------------------------------------------------------
Route Distinguisher: 100:2
SiteID Offset NextHop Range LabBase TunnelID FromPeer MHPref
--------------------------------------------------------------------------------
> 2 0 0.0.0.0 5 31744 0x0 0.0.0.0 0
----End
Configuration Files
l Configuration file of CE1
#
sysname CE1
#
vlan batch 10
#
interface GigabitEthernet1/0/0
ip address 10.1.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 10
#
return
l Configuration file of PE1
#
sysname PE1
#
vlan batch 10 20
#
mpls lsr-id 1.1.1.1
mpls
#
mpls l2vpn
#
vsi v1 auto
pwsignal bgp
route-distinguisher 100:1
vpn-target 1:1 import-extcommunity
vpn-target 1:1 export-extcommunity
site 1 range 5 default-offset 0
#
mpls ldp
#
isis 1
network-entity 10.0000.0000.0001.00
#
interface Vlanif10
l2 binding vsi v1
#
interface Vlanif20
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 7 VPLS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
794