Hypertherm Powermax30 AIR - Page 150

150 Powermax30 AIR Service Manual 808850
6 – Power Supply Component Replacement
8. Check for leaks at each fitting and hose connection point on the air filter assembly.
9. Complete the following procedures:
a. See Install the power supply cover on page 99.
b. Reconnect the power cord, and set the power switch to ON (I).
CAUTION!
If there are leaks in the gas supply hoses or connections:
 Cut speeds can decrease.
 Cut quality can deteriorate.
 Cutting thickness capability can decrease.
 Consumables life can be shortened.