Hypertherm Powermax30 AIR Service Manual

154 Powermax30 AIR Service Manual 808850
6 – Power Supply Component Replacement
9. Check for leaks and loose connections at each fitting and hose connection point on the air filter assembly.
10. Complete the following procedures:
a. See Install the power supply cover on page 99.
b. Reconnect the power cord, and set the power switch to ON (I).
CAUTION!
If there are leaks in the gas supply hoses or connections:
 Cut speeds can decrease.
 Cut quality can deteriorate.
 Cutting thickness capability can decrease.
 Parts life can shorten.

Hypertherm Powermax30 AIR Specifications

General

Built-in Air Compressor	Yes
Output Voltage	83 VDC
Input Voltage	120-240 V
Current Output	15–30 A
Cutting Thickness	Up to 10 mm (3/8 in) recommended cut
Gas Supply	Built-in air compressor
Operating Temperature	-10°C to +40°C (+14°F to +104°F)