9
INTELLIGENT ACTUATOR
Part 1 Installation
[3] Surge absorber
With both the global specification and standard specification, the motor drive part of the X-SEL controller
has no built-in surge absorber to protect the equipment against surge noises that may generate in the
controller due to lightning, etc.
Therefore, a surge absorber must be installed externally to the controller if you want to increase the surge
resistance of your equipment.
Caution: Be sure to use the following surge absorber to ensure compliance with the EC Directives.
Recommended surge absorber: R/A/V-781BXZ-4 by Okaya Electric Industries
Peripheral configurations for the global and standard specifications are shown on the following pages.
To Next Page
Loading...
Need help?
General
