Chapter 12. RAS, monitoring, and troubleshooting 693
8. Close the window and select either Resume or Cancel, as shown in Figure 12-39.
Clicking Resume continues the software update. Clicking Cancel cancels the software
update so that the user can correct any issues.
Figure 12-39 State after you run the test utility
9. Selecting Resume prompts the user to confirm the action, as shown in Figure 12-40.
Figure 12-40 Resume confirmation window
10.Wait for each node to be updated and rebooted, one at a time until the update process is
complete. The GUI displays the overall progress of the update and the current state of
each node, as shown in Figure 12-41.
Figure 12-41 Automatic update progress
To Next Page
Loading...
Need help?
General