694 Implementing the IBM Storwize V5000 Gen2 with IBM Spectrum Virtualize V8.1
During the update process, a node fails over and you can temporarily lose connection to
the GUI. After this situation happens, a warning is displayed, as shown in Figure 12-42.
Select Yes.
Figure 12-42 Configuration node failover warning
Updating the software manually by using the GUI and SAT
Complete the following steps to manually update the software by using the GUI and Service
Assistant Tool (SAT):
1. Browse to Settings → System → Update System and select Update and Test, as
shown in Figure 12-43.
Figure 12-43 Update system panel
Alternatively, you can run the test utility by selecting Test Only.
Important: We advise that you update the IBM Storwize V5000 Gen2 automatically by
following the update wizard. If a manual update is used, ensure that you do not skip any
steps.
To Next Page
Loading...
