Icom ID-E880

D Remote installation
The supplied remote controller bracket is used for remote in-
stallation.
These screws
are not supplied.
Remote controller bracket
• Attach the remote controller
bracket onto a flat surface
using 4 self-tapping screws
(2.6 mm(d)), or double-sticky
tape, etc., as at left, then at-
tach remote controller to the
bracket.
When installing into your vehicle
q
Remove two screws and magnets from the remote controller.
Remote controller
Magnet
FH M2.6 × 6 mm
FH: Flat head
CAUTION: NEVER use any other than the supplied
screws (FH M2.6 × 6 mm) if re-attaching the magnets to
the remote controller. Otherwise the transceiver’s internal
board may be damaged.
w Attach the removed magnets to the remote controller
bracket.
Remote controller bracket
Magnet
e Attach the supplied remote controller bracket as below.
Remote controller bracket (with magnets)
Remote controller
FH M2.6 × 8 mm
FH: Flat head
CAUTION: NEVER use any other than the supplied
screws (FH M2.6 × 8 mm) for attaching the remote con-
troller bracket. Otherwise the transceiver’s internal board
may be damaged.
r Attach the remote controller on to the optional MB-120 as
below.
Remote controller bracket
Optional
MB-120
Adjust the viewing
angle for maximum
visibility of the
function display.
V
QUICK REFERENCE GUIDE