AFL-xxx-CX2 Panel PC
Page 79
JP4 DESCRIPTION
1-2 +3.3 V
2-3 +5 V
Table 4-9: LCD Voltage Setup Jumper Settings
4.5.7 Panel Resolution (JP2)
This jumper selects the video resolution. This pin header is shared with the GPIO
connector. Only the settings relevant to panel resolution selection are shown here.
JP2 Description
5-6, 7-8, 9-10 640 x 480, 18-bit
7-8, 9-10 800 x 600, 18-bit
5-6, 9-10 1024 x 768, 18-bit
9-10 1280 x 1024, 36-bit
5-6, 7-8 800 x 480, 18-bit
7-8 1024 x 768, 24-bit
5-6 1280 x 1024, 48-bit
Open 1280 x 800, 18-bit
Table 4-10: COM2 Mode Select Jumper Settings
4.5.8 Touch Panel Type (J1)
The touch panel type selects whether the connected touch panel is a 4-wire or 5-wire
touch panel.
J1 DESCRIPTION
1-2 5-wire
3-4 4-wire
Table 4-11: Touch Panel Type
To Next Page
Loading...
Need help?
General
