IMO HD2-3.7A-43 - Page 151

HD2 Series Inverter Function Parameter List
-142-
Function
code
Name
Description
Default
value
Modify
P01.13
Deadzone time of
forward/reverse
rotation
This function code refers to the transition time of
the threshold set by P01.14 during setting
forward/reverse rotation of the inverter, as shown
below.
Output frequency f
Forward
Reverse
Deadzone
time
Time t
Starting
frequency
Switch over after
zero frequency
Switch over after
starting frequency
Setting range: 0.0–3600.0s
0.0s
○
P01.14
Forward/reverse
rotation
switchover mode
0: Switch over after zero frequency
1: Switch over after starting frequency
2: Switch over after passing stop speed and delay
1
◎
P01.15
Stop speed
0.00–100.00Hz
0.50Hz
◎
P01.16
Stop speed
detection mode
0: Set value of speed (the only detection mode
valid in SVPWM mode)
1: Detection value of speed
0
◎
P01.17
Stop speed
detection time
0.00–100.00s
0.50s
◎
P01.18
Running
protection of
power-on
terminal
When the running command channel is controlled
by terminals, the system will detect running
terminal state automatically during power-on.
0: Terminal running command is invalid during
power-on. The inverter will not run during
power-on even if the running command terminal is
detected to be valid, and the system is in running
protection state. The inverter will run only after this
terminal is cancelled and enabled again.
1: Terminal running command is valid during
power-on. The system will start the inverter
automatically after initialization is done if the
running command terminal is detected to be valid
during power-on.
Note: This function must be set with caution,
otherwise, serious consequences may occur.
0
○
P01.19
Action selected
when running
This parameter specifies the running status of
inverter when the set frequency is below the lower
0
◎